Why is my washing machine not doing spin cycle?
Why is my washing machine not doing spin cycle?
Normally, your washing machine won’t go into a spin cycle until it’s been drained. The drainage hose may become clogged with debris from your clothing, or it could be kinked. If the hose is kinked or crushed, it will likely need to be replaced.
How do I reset my Whirlpool wtw4950xw2?
RESET- Rotate the cycle selector knob counterclockwise to clear the sequence.
- Rotate the cycle selector knob clockwise one click and wait ½ second.
- Rotate the cycle selector knob clockwise one click and wait ½ second.
- Rotate the cycle selector knob clockwise one click and wait ½ second.
What causes a washing machine to not spin and drain?
If the washer won’t drain or spin, either something is stuck in the washing machine drain hose or pump, or the pump is broken.
Why does my washer agitate but not spin?
If your washer won’t agitate but spins, a broken agitator may be to blame. The agitator is the centerpiece in a top load washer that agitates and moves the clothes through the water during the wash cycle. The output shaft of the transmission is splined to the agitator to secure it in place.
How do you reset the spin cycle on a Whirlpool washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.
Does Whirlpool dishwasher have reset button?
Press the “Heated Dry” button, followed by pressing the “Normal” button, and then press both buttons again in quick succession. Once you’ve pressed the two buttons twice, your dishwasher should go into a diagnostic mode, which will cause it to reset. If it doesn’t work, try doing it again with the door open.
What causes a Whirlpool washer not to spin?
If your Whirlpool washer Not Spinning well, you need to check the pump. It could be clogged with debris or defective and needs to be replaced. To check the pump, disconnect the drain line and remove the back panel of your machine. Check for debris with a flashlight, or check with a special tool.
How do I reset my Whirlpool automatic washing machine?
If they are, press START / STOP one time. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.