What size Victor brand tip do you need to cut 1/2 inch material?
What size Victor brand tip do you need to cut 1/2 inch material?
Victor® Series 1 Type 101 Size 2 One-Piece Acetylene Cutting Tip is used to cut metal of thickness 1 – 1/2″.
How do I choose a torch tip?
4-Step Method of Selecting the Right Cutting Tips
- Metal Thickness. The thickness of the metal being cut is very important because the center hole of the cutting and gouging tip is sized to deliver the proper amount of oxygen at the proper pressure for a specific thickness.
- Application.
- Fuel Gas.
What pressure should I set my cutting torch?
The gas pressures should be set at 3 to 5psi for Acetylene, and 20 to 30psi for the oxygen, but when you squeeze the oxygen lever after the initial flame adjustment of the preheat flames to neutral just to a point where the feather disappears,the oxygen cutting stream should be visible and at least 4 inches in length …
What are the settings for oxygen and acetylene?
Recommended oxy/acetylene cutting tip pressures vary with size. If you have no manufacturer setting- information, and are cutting less than 1 ½” thick steel, set the acetylene regulator for 10 psig, and the oxygen regulator for 40 psig.
What are Victor torch tips made of?
Copper
Product Specifications
| Brand Name | RIVERWELD |
|---|---|
| Fabric Type | Copper |
| Item Weight | 3.17 ounces |
| Material | copper |
| Material Composition | Copper |
What size tip is recommended to cut the 1/4 in metal?
| Types: 100, 101, 104, 108, 110, 111, 112, 129 ( Oxy-Acetylene ) | ||
|---|---|---|
| Metal Thickness | Tip Size | Cutting Oxygen ( SCFH ) |
| 1/8″ | 000 | 20 / 25 |
| 1/4″ | 00 | 30 / 35 |
| 3/8″ | 0 | 55 / 60 |
Why is my acetylene torch popping?
The reason that an oxyacetylene cutting torch will pop and go out is because of a problem with gas flow. Usually this is either an issue with flow settings, a leak or blockage.
What happens if the torch tip is too large?
Excess Cutting Oxygen If the cutting oxygen pressure is too high or the nozzle size too large, a reduction in cut quality will result. Nozzles are made to operate within a limited range of torch pressures. Therefore, excessive oxygen pressure causes distortions in the oxygen stream once it leaves the nozzle.
Do you turn off oxygen or acetylene first?
oxygen valve
We recommend closing the oxygen valve first whenever turning off an oxy-fuel torch system especially when Acetylene is fuel.
Why is my torch popping?
The reason that an oxyacetylene cutting torch will pop and go out is because of a problem with gas flow. Usually this is either an issue with flow settings, a leak or blockage. In short, it could be a number of things.
Can acetylene be used in any tip?
Acetylene can be used in any tip. Any subtle physical movement can cause a ripple in the cut. A slight forward torch angle keeps the tip clean for a longer period of time. A cutting torch should never be used to cut open a sealed container.
What’s the difference between MAPP gas and acetylene?
Although acetylene has a higher flame temperature (3160 °C, 5720 °F), MAPP has the advantage that it requires neither dilution nor special container fillers during transport, allowing a greater volume of fuel gas to be transported at the same given weight, and it is much safer in use.