How much is a Sugar Bear Springer front end?
How much is a Sugar Bear Springer front end?
Sugar Bear front ends are so highly sought after that they require a deposit if you want to get your hands on one. After paying a deposit, the part will not be ready immediately as they are all hand-made, which can take some time. The average price of a front end is $3,000, with a $1,500 deposit.
Who makes Springer front ends?
Paughco Springer Front End for Harley-Davidson® Motorcycles – Paughco, Inc. No results found.
What is a Springer front end?
Springer Front Ends “Inline” refers to the steering stem and springer legs being in-line, versus an offset springer suspension, where the steering stem was staggered back slightly from the springer legs.
How are springer front ends measured?
Measure from the center/axle of the front wheel (with a properly inflated tire) straight up to the top of where the neck will be when the front frame rail is 6″ from the ground.
Does Sugar Bear still make front ends?
Today, Sugar Bear has a shop at his house; he is the sole employee. He still works all day, sells his front ends and builds custom bikes, but he is also heavily involved in protecting the history of choppers.
How old is Sugarbear?
50 years (December 13, 1971)Mike Thompson / Age
How do you measure a Paughco Springer?
Most springer lengths are measured from the top of the lower tree (where the lower neck stem bearing sits), to the center of the axle, but not Paughco. On page 36 of their catalog, Paughco shows their method of measurement: from the top of the rear leg to the centre of the rocker pivot on the rear leg…
What Harley came with a Springer front end?
The Drag Specialties Springer Forks were designed for Harley Softail, Sportster, and FXR models. The springer front ends will give your motorcycle that classic chopper look.
What is the stock length of a Springer front end?
22″
As a reference, on this springer that measurement is 22″, considered as the stock size.) Features: The reinforced top and bottom trees reduce flex and improve handling. Heavy duty, one piece forged rear legs.
How do you measure a motorcycle neck angle?
Raise the bike to an upright position, using a tape measure, hold the tape straight down from the front axle to the floor. Put a mark on the floor at that point. Then place the tape parallel to the steering neck, following the angle of the steering neck all the way up to the floor.
How old is Sugar Bear?