How do you use the Fisher and Paykel clean me cycle?
How do you use the Fisher and Paykel clean me cycle?
Cleaning the Inside of your Washer
- Add approximately 2 scoops of a powdered detergent directly into the detergent dispenser.
- Touch POWER to power your washer on (if it is not already) and turn the dial to the BASKET CLEAN cycle.
- Touch START/PAUSE to commence the cycle (refer to page 30 for details about the cycle).
How do I remove an Aquasmart agitator?
(a) Lift the lid and remove the low profile agitator cap by using an appropriate flat bladed screwdriver in one side of the slots. Lever the cap upwards until it disengages. The cap can then be removed by hand.
How do you balance a Fisher and Paykel washing machine?
Reduce the size of your load, or reduce the amount of powder being used as it can cause the bowl to bindle up on the shaft. Ensure an appropriate water level is selected for the load size (or select ‘Auto’ water level). Selecting a water level that is too high can cause out of balance loads, tangling or splash-over.
Which washing machine is the best in Australia?
10 Best Washing Machines in Australia [2021]
- Fisher & Paykel 7.5 kg WashSmart Top Load Washing Machine WA7560E1 – Washing Machine Australia.
- Samsung 8.5kg AddWash – Washing Machine Australia.
- Bosch 10kg Front Loader – Washing Machine Australia.
- Simpson SWT6055TMWA 6kg EZI Set Top Load Washer – Washing Machine Australia.
Does my Fisher and Paykel washing machine have a filter?
The pump has a filter to trap foreign objects that enter the washer along with clothing. The pump filter can be accessed from the front of the washer.
How do I clean sludge out of my top loader washing machine?
Clean the Washing Machine with Vinegar Again fill the washer with HOT water but this time add one quart of white vinegar. Same routine-set on the longest cycle and let it agitate a few minutes then sit for one hour. After the hour complete the wash and rinse cycle.
How do you take the agitator out of a washing machine?
Remove Agitator Reach to the bottom of the washing machine drum. Grab the lip of the agitator base with your fingers. Pull straight up to remove the agitator from the drum.
Why does my washing machine always go off balance?
A machine that is not level will rock during the spin cycle and cause the machine to be off balance. All four legs should be in firm contact with a solid floor. A carpeted surface can throw this balance off. If your washer is located on a pedestal, the problem can be amplified.