News

How do you reset the service light on a 2007 Renault Clio?

Standard

How do you reset the service light on a 2007 Renault Clio?

How to reset service light indicator Renault Clio 3 models with trip computer.

  1. Turn ignition ON, don’t start the car.
  2. Push and release display reset button 1 or 2 or press and hold buttons 1 and 2 simultaneously on the tip of the wiper lever until the Distance Before Next service information or Service DUE is displayed.

How do you turn the service light off on a Renault?

Reset service light indicator Renault Megane 3

  1. Switch ON the ignition, don’t start the car.
  2. Press and release the top button on the end of the wiper stalk until the Service required message appears on the display.
  3. .

How do I turn my service light off?

With the key out of the ignition find and press the odometer reset button (hold down) Turn the ignition on (warning lights come on) wait about 10-15 sec until most or the lights are off (still pressing odometer reset button) Turn ignition off (button still pressed) and remove the key. Release reset button.

What does it mean when your car says service required?

The service required light is mainly used to remind drivers when it is time to change the oil and filter, but could be used for other fluids or components. In the past, this light was similar to the check engine light and could mean that a fault has been detected by the system.

How do you reset the service light on a Renault Clio 2001?

From year: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005.

  1. Depress & hold the odometer reset button.
  2. Switch the ignition key to position 2, do not start the engine.
  3. After 30 seconds release the odometer reset button.
  4. Switch OFF the ignition.
  5. You may notice the display flashing or counting down.

How do you turn off the service light on a 2014 Renault Clio?

2012-2018 Renault Clio (MK4)

  1. Turn on the car. Put the key in, keep your feet off the pedals and press the START button once to put the car into Accessories mode.
  2. Go to the SERVICE INTERVAL.
  3. Hold down the TRIP button.
  4. Release the button and then hold it again.