How do you fix a 50.2 fuser error?
How do you fix a 50.2 fuser error?
Simple Steps to Correct 50.2 Fuser Error on HP LaserJet Printers
- Turn your printer off and unplug it.
- Remove the fuser and reinstall.
- Gently rock the fuser back and forth to make sure is secure.
- Plug the printer directly into a wall socket.
- Turn the printer back on.
What does 50.2 fuser error mean?
50.2 error indicates that the printer is not heating up fast enough. This can be caused by a bad heating element in the fuser but can also be caused when the printer does not have adequate power due to overloaded circuits or being plugged into a power strip or surge bar that limits current flow.
How do I fix a fuser error on my HP printer?
Solution one: Reset the printer
- Press the Power button to turn off the printer.
- Disconnect the power cord from the rear of the printer.
- Wait 30 seconds, and then reconnect the power cord.
- Press the Power button to turn on the printer. Wait for the product to start.
- Try printing again.
How do you fix a 50.0 fuser error?
50 error is a fuser error and means the fuser needs to be replaced. Do a search for the part on google and then see if it is worth repairing based on cost of the fuser and if you will need to hire someone to replace it for you.
What should be checked for a fuser error?
If you recently moved the printer around or if you recently installed a new fuser, particularly on HP LaserJet 4000, 4050, 4100, 4200, or 4300 series printers, you should check to see if two tabs on the fuser have come loose. (They can get dislodged during shipping, heavy movement, or during fuser installation.)
How long does a fuser last?
between 50,000 and 200,000 pages
The fuser unit is a vital component of laser printers. Most fusers last between 50,000 and 200,000 pages, depending on the design. Smaller cheap printers tend to have short fuser lives, while fusers used in larger office printers tend to be long-lasting and easily replaced.
When should I replace my printer fuser?
When should we replace a printer’s fuser?
- The print leaves parallel spots across a sheet.
- The printer begins to loosen toner and does not stick to the sheet.
- Stains on printed sheets.
- Annoying noise from gear wear.
- No heating due to lamp failure.
- The printer simply stops printing even though the paper goes all the way.
How do I fix 50.1 fuser error?
For a temporary fix, you can try turning your printer off and back on again. Sometimes the reboot will allow the fuser to reset itself and you can print a few more pages. If the 50.1 Fuser error message returns, it’s time to replace your fuser.
How long should a fuser last?
The fuser is a part of laser printers that bonds the toner and paper together using heat and pressure. Fusers need to be replaced every 75,000 – 300,000 pages depending on the printer model.
What causes a printer fuser to go bad?
Fuser error 50.3 signals that your machine is overheating. Your fuser may overheat due to the type of paper you use. If you use thick paper for a prolonged printing session overheating is likely to occur. Your printer would have to heat its fuser to a higher temperature to bond the toner to the thick paper.