General

How do I reset my Skytech remote?

Standard

How do I reset my Skytech remote?

To reset the codes, simply press and hold the same “Learn” button for a solid 10-15 seconds after which you should hear consecutive beeps indicating the memory has been cleared.

Are fireplace remotes universal?

Most of the remote controls are universal in nature, they will simply require you to place the receiver in such a way for ignition, and then the remote will do the rest. But a few types of fireplaces are far too unique and would require special installation by technicians.

Why does my Skytech remote not work?

Make sure all batteries are correctly installed in the transmitter and receiver. Also check that the batteries are fully charged. Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery.

Why won’t my remote work on my gas fireplace?

1) Batteries do not have enough power or are installed incorrectly. 2) Misunderstanding on how the remote features operate the fireplace. 3) The slide switch on the receiver is not in the correct position. 4) The remote hand-held transmitter has not had the “learn” function activated to the receiver.

Can I buy a remote for my gas fireplace?

Fireplace remote controls can offer plenty of different features to control your gas fireplace – from simple on/off control to thermostatic, there’s no question these remote controls can simplify your favorite appliance.

Can you use any remote for fireplace?

Whether or not you can use a fireplace remote with your fireplace will mostly depend on your gas valve type. Most of our remotes are designed to be used with millivolt gas valves, but we also have options for other specialty valves like servo motor valves and latching solenoid valves.

How do you reset a remote control?

For Android TVs released in 2015 or later, symptoms may improve by updating the software of the remote control….Reset the remote control.

  1. Open the battery compartment cover and remove the batteries.
  2. Press and hold the Power button for three seconds.
  3. Insert the batteries again and close the battery compartment cover.

How do I convert my gas fireplace to remote?

  1. Step One: Get a Smart Thermostat Remote And Receiver.
  2. Step Two: Install the Battery Into the Transmitter.
  3. Step Three: Insert Battery Into the Receiver.
  4. Step Four: Operating the Receiver Fireplace Remote.
  5. Step Five: Perform the Learn Function.
  6. Step Six: Installing the Receiver.
  7. Step Seven: Test the Remote Control Function.