How do I fix waiting for communication from primary decoder?
How do I fix waiting for communication from primary decoder?
First, ensure your connection is approved by Multichoice. Inform them of all the secondary decoders in your setup to ensure you get a strong signal. They will activate your setup after some time, and it will get rid of the “waiting for communication from primary decoder” error.
What does waiting for communication from primary decoder mean?
Therefore ensure that you insist on DStv approved cable to ensure a stable xtraview setup. If you do have a “waiting for communication from primary decoder Explora ” error, bad quality or damaged cable could be the cause.
Why is my DStv showing no communication from primary decoder?
The first cause of issues from primary decoder error occurs when your decoder hasn’t been activated by Multichoice. After you create an extra view connection, you must inform them of your signal activation. If you haven’t gotten the approval, you will experience a decoder error.
How do you connect a primary and secondary decoder?
The Heartbeat Connection Once you connect all the decoders to the LNB, proceed to link the decoders using a heartbeat or communication cable. The primary decoder uses a heartbeat cable to send a heartbeat signal every 2 – 3 minutes to a secondary decoder to confirm the connection.
How do you get a primary decoder signal?
Fix “No communication from Primary Decoder E143-0” During Xtraview Installation
- Check your Signal Quality.
- Set your Diplexer Correctly if using One.
- Make sure you get the Heartbeat Cables right if Connected directly.
- Check the distance between the two Decoders.
- Check your heartbeat cable for faults.
What causes no signal on DStv?
The reason your DStv says no signal is because there is an error in the DStv installation. This is caused by either a misaligned satellite dish, a faulty LNB, an improperly connected F-connector plug, loose cables or incorrect decoder settings on the LNB type.
Why is my secondary decoder showing no signal?
Why your DStv says no signal? The reason your DStv says no signal is because there is an error in the DStv installation. This is caused by either a misaligned satellite dish, a faulty LNB, an improperly connected F-connector plug, loose cables or incorrect decoder settings on the LNB type.
How do I know if my LNB is working?
How to Check a Satellite LNB
- First of all, disconnect the power of satellite TV receiver or Satcom modem and then check the LNB.
- Check the joints, if they are loose, screw them, or if they are corroded, you will have to replace it with a new one.
- Now check the LNB using satellite signal meter.