Contributing

How do I access Lantronix?

Standard

How do I access Lantronix?

  1. Open Device Installer (found in All Programs >> Lantronix >> Device Installer).
  2. Device Installer should automatically find the Lantronix Box upon opening; if not press search.
  3. Then either access the web configuration page tab or telnet tab and connect.
  4. Makes changes as needed and save .
  5. Test for communication.

How do you reset Lantronix?

How to reset a Lantronix Spider KVM to factory defaults

  1. Find which COM Port you will plug the Lantronix on. Open start button, type ‘devmgmt.
  2. Open a Hyperterminal. Open PuTTY, select the Serial option and type the dedicated port the press open.
  3. Connect the Lantronix.

How do I find my Lantronix IP address?

Open the DeviceInstaller software from the Lantronix folder in your All Programs. DeviceInstaller will automatically scan for any Lantronix devices on the network, the IP address will show under the description of the device.

How do I telnet into a Lantronix device?

Steps

  1. Log in to the Lantronix device via Telnet using port (9999).
  2. In the telnet configuration page go to “Change Setup.

What is the default password for Lantronix UDS1100?

3. Access Web Manager by entering the device IP address in the address bar of a browser. The device’s factory default username is left blank and factory default password is the last 8 characters of the Device ID (for devices manufactured after January 1, 2020) or is left blank (for all older devices).

What is Lantronix box?

Lantronix Device Servers enable M2M communications either between the computer and serial device, or from one serial device to another over the Internet or Ethernet network using “serial tunneling.” Using this serial to Ethernet method, the “tunnel” can extend across a facility or to other facilities all over the globe …

What is the default password for Lantronix uds1100?

How do you reset a Lantronix Spider duo?

How can I set a Spider or Spider Duo to factory defaults?

  1. Use the serial interface with a terminal emulator program set to.
  2. 9600 or 115200.
  3. Set your terminal emulator to 9600.
  4. Use a paperclip or something similar to push the reset switch thru the pinhole on the bottom of the Spider:

What is Lantronix Device Installer?

The Lantronix DeviceInstaller is a Windows-based GUI application that provides an easy way to install and configure specific Lantronix device server products. Using DeviceInstaller, you can: Load the appropriate firmware. Assign IP & other network specific addresses. Load custom web pages.

How do I update Lantronix firmware?

To upgrade firmware in the Web Manager, go to Device > Firmware Upgrade. Select a valid firmware image to upload. You can obtain the latest firmware and release notes for the gateway from the Lantronix Web site. Be careful not to power off or reset the device while uploading the new firmware.

What port does Lantronix use?

IP address of the device server to which the com port is connected. the com port is connected. All MSS products use port 3001 for channel 1 and 3002 for channel 2. All CoBos products (UDS, CoBox, and XPress) and XPort products use port 10001 for channel 1 and 10002 for channel 2.

What is a Lantronix box?