News

How do I ping a subnet?

Standard

How do I ping a subnet?

To perform a ping sweep:

  1. From a Microsoft OS command line, Type for /l %i in (1,1,254) do @ping -n 1 -w 100 . %i. For example, if the host network is 192.168.
  2. Press Enter.
  3. Observe the results as the command sweeps the network searching for hosts.

Does ping work across subnets?

No it won’t work , because both PC1 and PC2 are in between networks . Routing should to route traffic between different networks . For routing to run layer3 device is mandatory.

What happens when you ping a subnet address?

Hello, If someone is pinging from a subnetwork from a different network. Both networks will use their own gateways to send this traffic. If they have route to establish connection both will have successfull on the anwser (without firewall/acl to control traffic of course).

How do I find the subnet on a Cisco switch?

Use the show run interface interface_name command to view both the IP address and subnet mask.

How do I ping an entire network?

For Windows 10, go to Search in the taskbar and:

  1. Type “cmd” to bring up the Command Prompt.
  2. Open the Command Prompt.
  3. Type “ping” in the black box and hit the space bar.
  4. Type the IP address you’d like to ping (e.g., 192. XXX. X.X).
  5. Review the ping results displayed.

What is Fping command?

fping is a small command line tool to send ICMP (Internet Control Message Protocol) echo request to network hosts, similar to ping, but much higher performing when pinging multiple hosts.

How do I ping a host on a different network?

To ping another network device using a computer running Windows, complete the following:

  1. To bring up the run dialog, press the Windows key + R.
  2. Type cmd and press Enter.
  3. Type ping and press Enter. The IP address is XXX. XXX. XXX. XXX, where XXX is a number between 0 and 255. For example, to ping 192.168.

Can two computers with different subnet masks communicate?

The first half (where the mask is all ones) is the network and the second half is the host. All IP’s in the same network IP/mask can talk to each other directly, if the network portion does not match the Gateway is used to router the packets.

How ping works from one network to another?

Ping works by sending an Internet Control Message Protocol (ICMP) Echo Request to a specified interface on the network and waiting for a reply. When a ping command is issued, a ping signal is sent to a specified address. When the target host receives the echo request, it responds by sending an echo reply packet.

How do I ping an IP address on a Cisco Packet Tracer?

In the Desktop tab, click Command Prompt. . b. Type the ping command and the IP address for S1, and press Enter. Packet Tracer PC Command Line 1.0 PC> ping 192.168.

How do I find the subnet of a VLAN?

Use display ip-subnet-vlan interface to display IP subnet-based VLANs that are associated with the specified ports.

Is VLAN and subnet the same thing?

1. VLAN is a virtual or logical LAN its purpose is to communicate with other devices within the same LAN. A subnet is a logical partition of an IP network or it’s an IP address range of IP addresses and it helps hosts to communicate over layer 3 (Network Layer). 2.