Contributing

Is wipe-on poly a good finish?

Standard

Is wipe-on poly a good finish?

For most of us, polyurethane provides a combination of cost and durability that’s hard to beat. With wipe-on poly, you also get goof-proof simplicity, speed and convenience. It’s not only works on furniture, it’s also a great way to finish trim.

How do I get a smooth finish with wipe-on poly?

Wash it first with dish soap and water, then lightly sand the old finish with 220-grit sandpaper. Vacuum off the dust, then apply the finish as usual. Apply at least two coats to achieve an even sheen.

How many coats of Minwax Wipe-On Poly?

A single layer of wipe on poly is very thin, compared to poly you brush on. So I like to apply 7 to 10 coats.

Is Minwax Wipe-On Poly waterproof?

In Chris Minick’s article on wipe on finishes, the table suggest that Minwax Wipe-On Poly has excellent waterproof characteristics.

How tough is Minwax Wipe on Poly?

All but two of the finishes tested fared well, but the Minwax Wipe-On Poly was particularly impressive, drying in three hours to a light satin sheen and offering excellent water resistance. It’s a thin finish that requires more coats to build when brushing, but it still yields good results.

Does wipe-on poly yellow?

It’s easy to use, dries within a few hours, can be applied multiple times within 24 hours, dries completely clear, and doesn’t yellow over time. It comes in a variety of sheens, including satin, semi-gloss, and gloss. Polycrylic is also one of the more durable picks on this list.

Does Wipe on Poly yellow?

How long for Minwax Wipe on Poly to cure?

APPLICATION

  1. Apply a liberal amount of Wipe-On Poly to a clean, soft, lint-free cloth and rub it into the wood.
  2. Let dry 2-3 hours. Then lightly sand entire surface with fine sandpaper (220 grit) to ensure an even finish and proper adhesion.
  3. Apply a second coat.
  4. After final coat, allow 24 hours before light use.

Does Wipe-On Poly yellow?

Is Wipe-On Poly as good as brush on poly?

It takes about three coats to build up the same cover as one coat of brush-on polyurethane. In the interest of efficiency, it is best to use wipe-on poly on surfaces that won’t see quite as much wear and tear, such as furniture legs, trim, bookshelves, etc.

Is there a non-yellowing polyurethane?

The Best Non-Yellowing Water-Based Polyurethane The best non-yellowing clear coat is Minwax’s Polycrylic. It’s easy to use, dries within a few hours, can be applied multiple times within 24 hours, dries completely clear, and doesn’t yellow over time.