What size belt does a Go Kart torque converter take?
What size belt does a Go Kart torque converter take?
Measure from one side of the plate to the opposite side. If you’re running a standard torque converter the diameter will either be 6-inches, 7-inches, 7.5-inches or 8.5-inches.
What size belt do I need for a 30 Series torque converter?
Go-Kart Torque Converter Belt Size Chart
Brand | Model | Outer Circum. |
---|---|---|
Comet | 30 Series | 28.32″ |
Comet | 30 Series | 29.28″ |
Comet | 30 Series | 30.25″ |
Comet | 30 Series | 31.23″ |
What size belt does a 40 Series torque converter take?
40 series, length 33.87″, width 7/8″, used on many Manco karts and most Carter 40 series karts. 12346 Drive belt used on Manco model 710. 40 Series belt 7/8″ wide. Used on Comet 40 / 44 series torque converters, these belts are all 7/8″ wide.
What’s the difference between 30 and 40 Series torque converter?
The 30 series is rated for 2-8hp Engines and the 40 series is for 8-18hp engines. So if you’re using an unmodified predator 212 or other honda clones with a max power of 6.5hp or lower, then 30 series is for you, if you’re using a more powerful engine such as the Predator 420 then go for the 40 series.
How wide is a 30 series belt?
3/4″
It will replace Manco 5959, Comet 30 Series Drive Belt #203589, and Kartco #7628. Outside circumference is 27-5/8” width is 3/4″.
What is the difference between a 30 Series and 40 Series torque converter?
Can you adjust a torque converter?
Even though a torque converter can deliver different levels of torque at different rpm ranges, you’re still able to adjust it.
Why do torque converters eat belts?
Overloading the Torque Converter If his range is exceeded, it can cause excessive wear on the belt and pulley system as well. If you constantly drive uphill at slow speed, especially with a heavy load, this will also prematurely burn out the belt on your torque converter because it is “slipping” the entire time.
What size V-belt do I need?
Use a cloth measuring tape (not a steel one) and wrap it around the outside of the belt. You also use a thin string to take this measurement and place it on a steel tape to get the correct length. Next, for “A” Belts (1/2” width) subtract two-inches from the outside measurement to select the correct V-belt.
What do V-belt numbers mean?
Automotive belts start with either 4L (12.5mm wide) or 3L (9.5mm). The number following it is the outside length of the belt in tenths of inches. The inside length of the belt is typically 2″ less for a 4L belt, and 1-1/2″ less for a 3L belt. An example would be 4L460, which would be 46″ long outside, 44″ inside.