Questions

How do I get to Juniper config mode?

Standard

How do I get to Juniper config mode?

Switch Between Operational Mode and Configuration Mode

  1. When you log in to the device and type the cli command and press Enter, you are automatically in operational mode:
  2. To enter configuration mode, type the configure command or the edit command in CLI operational mode.

How do I change my juniper configuration?

To configure by copying a configuration:

  1. Go to the [edit interfaces at-1/0/0] hierarchy level and copy unit 61. [edit interfaces at-1/0/0] user@host# copy unit 61 to unit 62.
  2. Take a look at the new configuration and see what you need to change to make the configuration valid.
  3. Change the configuration to make it valid.

What is CLI configuration?

The Cisco IOS command-line interface (CLI) is the primary user interface used for configuring, monitoring, and maintaining Cisco devices. This user interface allows you to directly and simply execute Cisco IOS commands, whether using a router console or terminal, or using remote access methods.

How do I check the last configuration change in Juniper CLI?

To configure this type of logging, follow these steps:

  1. In configuration mode, go to the following hierarchy level: [edit]
  2. Configure the log file: [edit system syslog]
  3. Configure the change-log facility and severity level: [edit system syslog filename ]
  4. Verify the configuration:
  5. Commit the configuration:

How do I enter config mode?

To enter global configuration mode, enter the configure command. Global configuration From privileged EXEC mode, enter the configure command. To exit to privileged EXEC mode, enter the exit or end command, or press Ctrl-Z. To enter interface configuration mode, enter the interface configuration command.

What is the use of configure exclusive command?

Using the configure exclusive command, you can make changes without interference from other users. Other users can enter and exit configuration mode, but they cannot make any permanent changes to the configuration.

How do I set up Juniper devices?

Product and Release Support

  1. Connect to the device through the console port.
  2. Power on the device and wait for it to boot.
  3. Log in as the user root .
  4. Start the Junos OS command-line interface (CLI):
  5. Enter Junos OS configuration mode:
  6. Configure the hostname of the device.

How do you show interface in Juniper?

Use the show interfaces command to view the interface speeds. (Optional) Display the specified level of output. (Optional) Display interface description strings. (Optional) Display media-specific information about network interfaces.

What are the types of configuration mode?

There are five command modes: global configuration mode, interface configuration mode, subinterface configuration mode, router configuration mode, and line configuration mode. After an EXEC session is established, commands within Cisco IOS Software are hierarchically structured.

How do you check commit changes in Juniper?

show system commit

  1. Syntax. content_copy zoom_out_map. show system commit
  2. Description. Display the system commit history and pending commit operations.
  3. Options. none.
  4. Required Privilege Level. view.

Where is Junos config stored?

juniper.conf.gz file
For SRX Series Services Gateways running Junos OS Release 10.0 or later, the current operational Junos OS configuration is stored in the juniper. conf. gz file. The last three committed configurations are stored in the files juniper.

Which command is enter in interface configuration mode?

interface configuration command
To enter interface configuration mode, enter the interface configuration command. Interface configuration From global configuration mode, specify an interface by entering the interface command followed by an interface identification. To exit to privileged EXEC mode, enter the end command, or press Ctrl-Z.