How do I reprogram my Simon XT?
How do I reprogram my Simon XT?
Simon XT – Programming A Door/Window Sensor
- Press or until you get SYSTEM PROGRAMMING, then press.
- Enter Installer Code 4321 (Call Brinks Home Technical Support if this code is different)
- Press or until you get SENSORS, then press.
- Press again to place Simon XT into sensor learn mode.
What is the default installer code for a Simon XT panel?
Installer code Depending on how the access code is set, the default installer code is 654321, 54321, 4321 (factory default), or 321.
How do I clear Simon XT status?
Clearing Status: To clear system status, press the STATUS button, read and/or listen to the status messages, then press DISARM. If the trouble condition was a low system battery, perform a sensor test. The STATUS light should turn off if all trouble conditions have been corrected.
How do I get my Simon XT to stop beeping?
To stop the touch screen from beeping, go into the SETTINGS menu and turn the VOLUME all the way down. This should stop it from beeping and then call Technical Support during available hours for further assistance. I cannot arm my system. Press the STATUS button.
How do you put a sensor in a Simon XT?
Wireless sensors are assigned to a wireless zone on the Simon XT System. Therefore, adding a wireless zone is essentially the same thing as adding a wireless sensor. To add a sensor, keep pressing the down arrow in the System Programming Menu until the option “Sensors” is displayed. Then press the “OK” button.
How do you silence trouble beeping on Simon XT?
Simon XTi – Silencing Trouble Beeps
- Press GEAR icon at the bottom right then press DOWN ARROW 3 times.
- Press ENTER by Programming then enter the Master Code, then press OK.
- Press SIREN OPTIONS then UNCHECK Trouble Beeps then press CLOSE to exit.
- Press CLOSE again to exit programming.
What is the master code for?
Introduction. The MasterCode is a computer code that allows to fit different versions of the Minimal Supersymmetric Standard Model (MSSM) to currently existing experimental data.
How do I disarm my alarm without code?
Remove the AC power to the home alarm console from the wall directly. Use your console’s access key (or another item such as a small screw) to unlock and open the system’s backing. Lastly, disconnect at least one of the wires that are attached to the system’s main battery, which is blocky and noticeable in most units.